- Information
- Used to connect a Futaba telemetry equipped receiver to an extra voltage port.
- Cable, Fuse, Heat Shrink Tube and Instructions
- Length: 700 mm
- This voltage cable plugs into the R7008SB next to the antenna.
- This measures the external voltage, such as the battery that is running a motor. The voltage will be displayed in the transmitter as "EXT-VOLT".
- Maximum voltage is 70 volts.
- Cable should be cut to desired length, then remove & save 30mm from the positive black line. Next, solder the fuse inline on the positive wire and reattach the section of wire that was previously removed and solder into place. The fuse should be attached as close to the external power supply as possible. Place shrink tubing over the fuse and cover all sodered areas. Shrink the tubing onto the wire with a heat gun. The cables will then be connected to corresponding + & - wires that connect the ESC to the battery and attached using solder and shrink tubing.
This is the Futaba CA-RVIN-700 External Voltage Input Cable.FEATURESINCLUDESSPECIFICATIONSCOMMENTS- Specifications
-
- Parts
-
- Popular Accessories
- Downloads
-
- GPSR
-
Manufacturer
Registred contact information for the products manufacturer.
Name Futaba Corporation Address 1080 Yabutsuka
Chosei-mura, Chosei-gun, Chiba-ken299-4395 Chosei Country Japan Phone 001-81475326173 Email info@m.futaba.co.jp Homepage www.futaba.com
Importer
Registered contact information for the responsible company within the EU.
Name Minicars Hobby Distribution AB Address Annelundsgatan 17
74940 Enköping Country Sverige Phone 0046-0171143000 Email info@minicars.se Homepage https://www.minicars.se - Flik
-