Pro Sprayer Bottle 600ml VITON

M-DRIVE Pro Sprayer Bottle 600ml VITON

• Heavy Duty construction
• Chemical resistant VITON seals
• Suitable for most hobby chemicals (PH1-9)
• High output sprayer pump action
• Adjustable nozzle
• Total volume: 630ml
• Graduated scale in ml (600ml)
• Graduated mix-scale in procent (2-10%)
• Size: 265 x 110 x 80mm
• Weight (without fluids): 98g

• Automotive alkaline degreasers
• Automotive car shampoos
• Water (use at home while spraying your flowers etc)
• Dishwashing fluid (mix a small amount with water for cleaning windows/mirrors)
• Disinfectant surface cleaning fluids (for gyms etc)
• It even works with denatured cleaning alcohol/ethanol! (The seals are not 100% optimized for that but our test have shown it works much better that most other sprayers on the market!)
• The expected lifespan of the pump can vary depending on how it's used and what chemicals that have been used

1. Fill the Pro Sprayer bottle with water up to the H2O grade (see the grades on the edge of the bottle - it’s approximately 570ml).
2. Add 6% of normal concentrated automotive alkaline pre-cleaner fluid. This is the type of ”degreaser” that actually aren’t degreasing per say - but it cleans normal dirt and is normally used as a pre-cleaning fluid if you have a really dirty full scale car (spray it on, let sit for a while and then rinse off with water before shampooing it etc). Note, don’t confuse it with a automotive naphtha based degreaser fluid as that is much more aggressive and also degreases your bearings etc (don’t use that type for this application).
3. Add 4% of a normal automotive car shampoo. It really doesn’t matter what you use for this application. If you don’t have any in your garage already, get a non expensive one.
4. Mix done. The perfect cleaning solution for your RC car or MTB bike etc.

• Brush off loose dirt with a brush (paint brush of tooth brush)
• If you have a vehicle with ”waterproof” electronics - make sure the sealing o-rings in the servo(s) and receiver box are seated and looks ok.
• Use the cleaning fluid mix described here above and spray it on your dirty RC car. Let it sit for a few minutes - before it dries use a tooth brush or paint brush to agitate the dirt and then rinse it with water.
• Use a soft cloth/towel to dry it off and let it sit to completely dry.
• When dry, check that the suspension moves freely, check to see of there any screws or nuts that have come lose etc (tighten or replace them).
• Use a small amount of spray oil to lubricate the bearings (like WD40).
• Use suitable protective gloves and clothes when using chemicals such as these.