ZL21 No-prep Dragracing body 1/10

Bittydesign ZL21 - No-Prep Dragracing Body 1/10

• Made with high quality and genuine polycarbonate Lexan®, 1mm thick
• Included in the kit is a complete set of screws, nuts and washers necessary for correct fixing of the additional parts
• The additional front splitter, exhaust pipes and rear wing are also supplied with the body shell
• Specs: length 640mm, width 280mm, height 164mm
• Wheelbase: 330mm
• Sold clear with protective film outside
• Included in the package a decal sheet pre-cut and the windows mask

• Rear wing (extension) to improve and "clean" the air turbulence generated in the rear
• Exhausts to give a real look, 'option 1' is a set of zoomie style pipes (4 tubes) or 'option 2' is a turbo style exhaust (single pipe); you will choose which one to mount based on your preference
• Front splitter to create a more aggressive appearance, as well as help increase front end stability

• Step 1: decide, first of all, if mount on your new ZL21 body shell the single big tube rather than the 4 tubes in line with smaller section
• Step 2: cut out with quality scissors (see here) the plates with the style of exhausts that you prefer
• Step 3: cut out the hole (marked on the side left/right) on the body, longer if you wanna install the 4 tubes, short hole if you decided to apply the single exhausts tube
• Step 4: apply a double side tape over the exhausts plate and press it inside the body
• Step 5: enjoy the racing and realistic look!