After Run Olja 50ml
Artnr:
OP101909K
Lev.artnr:
101909K
Lagersaldo:
0 st
Cirkapris:
90 kr
- Information
- After a day of running the engine - empty the fuel tank of most of it's fuel. Leave enough fuel for the engine to be able to run a couble of minutes at idle speed.
- Start the engine, let it idel and reach working temp and let it idle until the remaning fuel in the tank is empty, as in the engine stops by istelf.
- Try starting the engine again until you are sure that there is no more fuel in the tank/fuel lines or the engine itself.
- Remove the glowplug and remove any airfilter system.
- Add a few drops of OptiFuel after-run oil through the glowplug hole and the carburettor opening.
- Spin the engine carefully/slowly a few times to spead the oil inside the engine and bearings.
- Inspect the glowplug and check it's condition - replace if needed.
- Re-install the glowplug.
- If your engine has an airfilter system (car engines) - clean it and/or replace it. If it's a "wet oil" filter - re-apply the foam with a special airfilter oil.
- Re-install the airfilter.
OptiFuel 101909K - After-Run Oil 50ml
This is a bottle of after-run oil suitable for all internal combustion engines (mostly run on methanol/nitro based fuels).
The oil also works good as an engine assemble oil.
Directions:- Egenskaper
-
- Delar
-
- Populära Tillbehör
- Nedladdningar
-
- Flik
-
Kompletterande produkter:
![Multi Glödstift Verktyg - Muttrar: 8/5.5mm & Insex: 2.5/5mm]()
Artnr:
Lagersaldo:
46 st
Cirkapris:
208 kr
Se fler varor
